Page 42 - Noisy-User-Manual-2017-en

40 2 Program concepts

NOISY offers the following device drivers:
 1. 1. Serial
Standard interface for sound level meters, e.g., LD-824 etc. (device driver
included in the basic version)
 2. TEAC DF-1
Can be used to drive the analyzer DF-1 by TEAC via the parallel
interface.
 3. Sound card
Can be used to utilize the sound card as a sound level meter (device
driver included in the basic version).
 4. Rion NA-27
5. Rion NL-15
This device driver can be used to drive the sound level analyzers NA-27
and NL-15 produced by Rion with NOISY. To do this, go to the
Configure sound level meter dialog box and activate device type “Rion
NA-27 (serial)” or “Rion NL-15 (serial)” and the setup file “Rion_NA-
27.nss” or “Rion_NL-15.nss”.
NL-18 can be driven via the standard Serial device driver.
 6. Rion NL-22/-32
The Rion NL-22/-32 device driver can be used to drive the sound level
analyzers NA-22 and NL-32 produced by Rion with NOISY as well. To
do this, go to the Configure sound level meter dialog box and activate
device type Rion NL-22/-32 (serial) and the setup file
Rion_NL_22_32.nss.
 7. Larson Davis 831 (USB)
 8. Norsonic 140 (USB, serial)
 9. 01 dB DUO
The 01 dB DUO device driver can be used to support the sound level
meter DUO produced by Acoem.
 10. 01dB block mode
The 01dB block mode device driver can be used to support the Acoem
sound level meters with measurement data that are stored on FTP servers
block by block.

You can see and check all these version in the Demo version installed from
the CD ROM.